Naiss

Eggy
20:16:47 hi
­
coolgsm2000
20:17:31 how is infra doing bossi
20:17:59 i hope u remeber me
20:18:17 (A)
­
Eggy
20:19:38 Well....it is working, but jerking-off also. During almoust every soldering cycle I have to switch it off and on again. It just stops heating...for ex: i preheat the board to 100C, then switch on the top heater and then the temperature of the chip is rising...quite often i have had times when reaching almoust to the soldering temperature the temp is not rising anymore...switch it off and on again and it works again...but quite annoying
­
coolgsm2000
20:20:42 yes
20:20:51 because is manuel ma chine simple
20:20:52 logic
20:20:56 cheap and good that all
20:21:06 u expecting some profiles then wrong person
­
Eggy
20:21:44 Cheap or not the machine should not stop heating just at some moment it is still switched on
­
coolgsm2000
20:22:05 yes because the working is diffrent
20:22:12 if u have some idea
20:22:20 u can make a design i can mass produce it
20:22:21 simple
20:22:32 if u expect the moon is not possible
­
Eggy
20:27:34 So it is perfectly normal, that ~600USD costing machine may just randomly stop working and needs "hard reset" to get it back online?
­
coolgsm2000
20:27:46 for you
20:27:49 this alway problems
20:27:53 i sld 50 set
20:27:59 not a single user report me this problems
20:28:04 so choice for u return back
20:28:10 all the goods i refund u the money
20:28:15 simple and sweett